Tel-Tru 3583 Pressure Gauge
Tel-Tru® type 3583 sanitary pressure gauges are meant for the pharmaceutical industry. They feature heavy duty waterproof construction, Clean in Place (CIP), a pulsation dampening system, Rezero feature, and are repairable. This line is also available in model 2583 with a 2½” dial and model 5083 with a 5″ dial.
Data SheetAdditional information
| Manufacturer | |
|---|---|
| Series | |
| Dial Size | 2.5"(63mm), 3.5", 5" |
| Gauge Connection | 1 1/2" Tri-Clamp, 2 1/2" Tri-Clamp, 2" Tri-Clamp, 3" Tri-Clamp |
| Reading Type | Mechanical |
Tel-Tru 3583 DataRelated Products
-
Tel-Tru CS/CM/CL Specialty Thermometer
Specialty ThermometersManufacturer Series Thermometer Type Tel-Tru CS/CM/CL Surface The Tel-Tru® CS, CM, & CL series clip-on pipe thermometers are designed for clipping on to pipes or tubes ¾” to 23⁄8” in diameter. Three different clip sizes include: small, medium, and large.
Data Sheet -
Tel-Tru 3581 Pressure Gauge
Sanitary Pressure GaugesSeries Dial Size Gauge Connection Reading Type 3581 2.5"(63mm), 3.5", 5" 1 1/2" Tri-Clamp, 2 1/2" Tri-Clamp, 2" Tri-Clamp, 3" Tri-Clamp Mechanical Tel-Tru® type 3581 sanitary pressure gauges are meant for the chemical industry. They feature heavy duty waterproof construction, Clean in Place (CIP), a pulsation dampening system, Rezero feature, and are repairable. This line is also available in model 2581 with a 2½” dial and model 5081 with a 5″ dial.
Data Sheet -
Tel-Tru 55 Low Pressure Gauge
Low Pressure GaugesDial Size Connection Mounting Case Material 2.5"(63mm) 1/4 NPT Lower Steel Tel-Tru® 55 series gauges are low pressure diaphragm-actuated utility pressure gauges. They are designed for use with air, gas, water, oil or any medium not corrosive to brass or bronze and where pressure of less than 10psi is to be measured.
Data Sheet -
Tel-Tru SH Specialty Thermometer
Specialty ThermometersManufacturer Series Thermometer Type ENFM SH Surface The Tel-Tru® DM & TB series surface thermometers are 2″ dial compact thermometers that sense surface temperature. Exposed bimetal coil sensors provide a quick and accurate surface temperature reading. Series DM are dual magnet thermometers designed for horizontal or ferrous non-horizontal surfaces. They feature two Alnico magnets that act as a base and hold the thermometer in place. Series TB tab thermometers are designed with two tabs with pre-drilled holes for screws. Two mounting configurations are available — surface or flush.
Data Sheet
